Sherwood Newcastle R-872 Operating Instructions Manual page 22

6.
Operate the component using the corresponding
function buttons.
• If any of buttons fails to operate as they should,
start from the step again to enter the correct setup
1
code.
Note :
• Manufacturers may use different setup codes for
the same product category. For that reason, it is
important that you check to see if the code you
have entered operates as many controls as
possible. If only a few functions operate, check to
see if another code will work with more buttons.
7.
Repeat the above steps 1 to 6 for each of your
other components.
Searching a setup code
• In addition to enter a setup code using "Setup
Code Table" on page 77, it is also possible to
search through all the codes that are stored in the
library of this remote control.
1.
Turn on the component you want to operate.
2.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 21 to select the setup
code mode ("CODE").
3.
While "PRESET" is displayed, search a setup
code, aiming the remote control at the remote
sensor on the component.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the setup code is selected
one by one.
• If the selected code is correct, your component
will be turned off.
• When your component is not turned off, repeat
this step until you find one that works.
4.
While "PRESET" is displayed, press the ENTER
button to store the setup code.
• Then "OK" is displayed on the LCD screen.
5.
Operate the component using the corresponding
function buttons.
• If any of buttons fails to operate as they should,
start from the step 1 again to find the correct
setup code.
6.
Repeat the above steps 1 to 5 for each of your
other components.
22