Sherwood Newcastle R-872 Operating Instructions Manual page 27

Continued
3.
While the device is displayed, press the
CURSOR UP(▲)/DOWN(▼) buttons to select
the desired punch-through device, then press
the ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, depending on the selected
punch-through mode, punch-through devices
and the one punch-through deleting mode
("DELETE") are selected as follows :
• In case of the volume punch-through,
AUDIO DELETE
→
• In case of the transport punch-through,
CD DELETE DVD
→
• In case of the channel punch-through,
TV DELETE SAT
→
• Then "OK" is displayed and the current punch-
through mode is displayed.
4.
While the punch-through mode is displayed,
repeat the above steps 2 and 3 to program other
punch-through function under the same master
device mode.
5.
To program punch-through functions under
other master device mode, repeat the above
steps 1 to 4.
TV
←
VCR AUX
←
CABLE VCR
←
Operating a punch-through function
• While this remote control is set to control a
master device, aim the remote control at the
REMOTE SENSOR of the punch-through device
and press the desired button of the programmed
punch-through controls.
Example: When pressing "PLAY (▶)" button.
• Then the punch-through device is displayed on
the LCD screen.
Erasing the programmed punch-through
function
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 21 to select a master
device and the punch-through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for
several seconds.
2.
While "VOL" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the punch-
through mode to be erased, then press the
ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the mode changes as
follows:
VOL DELETE
→
• Then the device is displayed .
27
PLAY CH
←