Sherwood Newcastle R-872 Operating Instructions Manual page 25

Programming a macro function
• The macro function enables you to program a
series of button operations(up to 15) on this
remote control into a single button.
• You can store up to three separate macro
command sequences into "M1", "M2" and "M3"
buttons.
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 21 to select the macro
mode ("MACRO").
• Then "M1" is displayed on the LCD screen for
several seconds.
• During macro setting operation, pressing any of
the DEVICE buttons cannot exit from the macro
mode.
2.
While "M1" is displayed, press the CURSOR
UP(▲)/DOWN(▼) buttons to select the MACRO
button to be programmed into, then press the
ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, "M1", "M2" or "M3" is
selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 1.
3.
While "SEL" is flickering, press the operation
buttons you want to program in order.
Example: When playing a DVD on the DVD player
connected to VIDEO 2 jacks of this
receiver.
①. Press "AUDIO" button to control this receiver.
②. Press "POWER ON" button to turn this
receiver on.
③. Press "VIDEO 2(7)" button to select the
desired input source.
④. Press "DVD" button to control the DVD player.
⑤. Press "POWER ON" button to turn the DVD
player on.
⑥. Press "PLAY (▶)" button to start playback.
• Each time the operation buttons are pressed, the
programmed order is displayed.
4.
Press any of the MACRO buttons (M1~M3) to
complete the programming.
• Then "OK" is displayed.
To erase a macro program
• When erasing a macro program, perform the
above steps 1, 2 and 4, but ignore the step 3.
To change a macro program
• When a new macro program is stored into a
MACRO button with performing the above steps
1 to 4, the previous macro program is erased
from the memory of the MACRO button.
25