Vitek VT-1330 Manual Instruction page 5

•
If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or similar
qualified personnel to avoid danger.
•
Do not use the unit if the power cord or plug is damaged,
if the unit works improperly or after it was dropped.
•
Do not attempt to repair the unit. Do not disassemble the
unit by yourself, if any malfunction is detected or after it
was dropped, unplug the unit and apply to any autho-
rized service center at the contact addresses given in
the warranty certificate and on the website www.vitek.ru.
•
To avoid damages, transport the unit in the original
package only.
•
Keep the unit in a dry cool place out of reach of chil-
dren and disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USE ONLY.
ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION
AREAS AND WORK SPACES IS PROHIBITED.
USING THE HAIR DRYER
After unit transportation or storage at low tempera-
ture keep it for at least three hours at room tempera-
ture before switching on.
– Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
– Remove any advertisement stickers that can hinder
the unit operation.
– Unwind the power cord completely.
– Insert the power plug into the mains socket.
– Select the required operation mode using the
switch (1):
«0» – the hairdryer is switched off;
«1» – low temperature and speed airflow;
«2» – maximal temperature and speed airflow.
Note: During the first operation some foreign smell
and a small amount of smoke from the heating element
is possible, it is normal.
Nozzle
Use the nozzle (3) when you need to focus the power
of drying on a small area (for example, a curl or a wave)
or when you want to straighten wavy hair.
ENGLISH
5