Remote Control Battery Installation; Remote Control Operating Range; Adjustable Feet - Sanyo PLC-XU105 Owner's Manual

Remote Control Battery Installation

Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.

Remote Control Operating Range

Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector.

Adjustable Feet

Projection angle can be adjusted up to 8.9 degrees with the
adjustable feet.
Lift the front of the projector and pull the feet lock latches on
both side of the projector upward.
Release the feet lock latches to lock the adjustable feet and
rotate the adjustable feet to a proper height, and tilt.
Keystone distortion can be adjusted automatically with
the Auto setup function or manually by using the menu
operation (see pages 23, 43-44).
Install new batteries into
2
the compartment.
Two AA size batteries
F o r c o r r e c t p o l a r i t y
( + a n d – ) , b e s u r e
battery terminals are in
contact with pins in the
compartment.
Part Names and Functions
Replace the
3
compartment lid.
30°
30°
Remote control
Adjustable Feet
16.4'
(5 m)
Feet Lock Latches
13