Error Messages - Casio KL-7400 User Manual

Error Messages

Message
• The last time the printer was
PRINTER NOT SHUT
DOWN PROPERLY used, the AC adaptor was
LAST TIME disconnected or the batteries
were removed while the
printer was turned on or
while PLEASE WAIT was
displayed, so the printer
could not power down
properly. Because of this,
some data in printer memory
became corrupted.
➜ Press any key to re-initialize
the data at the corrupted
location.
• You are trying to print
INPUT A VALUE!
numbering labels without any
input.
➜ Input the numbers you want.
• To print, press SET.
LABEL LONGER THAN
• To cancel printing, press
SETTING
SET/ESC ESC. You can then decrease
the number of characters,
change to a longer tape
setting, or select auto tape
length.
• You are trying to print
LENGTH OF PRINT IS
TOO LONG! something that is longer than
the length of tape available.
➜ Make the label shorter or
reduce the number of copies.
Cause and Action See page:
10, 11, 47
24
30
17, 30
Message
• There is no tape cartridge
LOAD A TAPE
CARTRIDGE loaded in the printer or the
tape cartridge is not loaded
correctly.
➜ Check the tape cartridge.
• Battery power is low.
LOW BATTERY!
➜ Replace the batteries or use
the bundled AC adaptor to
power the printer.
• Temperature is below 10˚C
(50˚F)
➜ Move the printer to a location
where the temperature is
within the operating
temperature range (10˚C to
35˚C (50˚F to 95˚F)).
• Battery power is low.
LOW BATTERY!
➜ Replace the batteries or use
CONTINUE TO
PRINT? the bundled AC adaptor to
SET/ESC power the printer.
• Temperature is below 10˚C
(50˚F)
➜ Move the printer to a location
where the temperature is
within the operating
temperature range (10˚C to
35˚C (50˚F to 95˚F)).
See page:
Cause and Action
13
47
47
53
E