Error Messages - Casio KL-8200 User Manual

Error Messages

Message Cause and Recommended Action
SAME NAME Name being assigned to a preset
ALREADY format is already used. Use a differ-
USED!
ent name.
DATA ITEM No match for characters specified for
NOT FOUND! a search operation. Change to other
characters or use sequential search.
TOO MANY Too many lines to be printed. Reduce
LINES! the number of lines or use a wider
tape.
TOO MANY Too many lines for printing with a
LINES TO frame. Reduce the number of lines
FRAME! or use a wider tape.
• Odd number of digits input for ITF
ODD NUMBER
OF DIGITS!
bar code when a check digit is not
CANNOT being used. Add a 0 (zero) as the
PRINT first digit and re-input.
• Even number of digits input for ITF
bar code when a check digit is
being used. Add a 0 (zero) as the
first digit and re-input.
NOT ENOUGH Bar code print printed does not have
DIGITS! enough digits. Re-input with the
CANNOT proper number of digits.
PRINT
RESET! Memory has not been initialized yet.
Perform the reset operation.
SEND ERROR! Label printer was unable to receive
data being sent from an external
source. Check cable connections
and parameter settings.
POWER OFF Printing operation performed while
THEN LOAD A
the tape cartridge compartment is
TAPE empty. Load a tape cartridge and try
CARTRIDGE
again.
TEXT DOES
Text being printed does not fit within
NOT FIT! a fixed-length tape. Shorten the text
or change the tape length.
Message Cause and Recommended Action
TEXT DOES Text being printed with a frame does
NOT FIT! not fit within a fixed-length tape.
Shorten the text or change the tape
length.
DATA ERROR! Print operation attempted when
RESET! memory is not initialized. Perform the
reset operation and try again.
DATA ERROR! Memory data has been deleted or
RESET! corrupted bacause battery went
dead.
DATA ERROR! Text storage attempted when
RESET! memory is not initialized. Perform the
reset operation and try again.
NO DATA! Recall or delete operation attempted
while there is no more data in
memory. Press SET to clear the er-
ror message.
TOO MANY BL! Attempt to input a 16th block mark
(only 15 are allowed). Delete block
marks you don't need.
• Invalid characters used in a bar
ILLEGAL
CHARACTERS! code. Change to allowed charac-
CANNOT ters.
• Letter other than A, B, C, or D in-
PRINT
put for CODABAR bar code start
code or end code. Use only the
allowable characters.
MEMORY Memory used for data communica-
FULL! tion is full. Reduce the amount of
data being transferred.
Memory used for storage is full. De-
lete data in memory that you no
longer need.
NOT ENOUGH
Operation being attempted would
MEMORY!
cause memory used for storage to
become full. To store more, delete
data in memory that you no longer
need.
If you don't want to store more, press
SET to clear the message and then
continue with the operation.
Message Cause and Recommended Action
BACK-UP Memory backup battery power is
BATTERY low. Replace the battery.
GETTING
WEAK!
PLEASE
REPLACE IT!
CANNOT Recalling text into existing text re-
COMBINE! sults in more than 255 characters.
Reduce the number of characters in
existing text.
Recall operation incorporating re-
called text into existing text would
result in more than 15 block marks.
Reduce the number of block marks
in the existing text and try again.
INPUT TEXT! Attempt to register characters when
no characters are input. Input char-
acters and try again.
E-33