ECS C7VCM2 Manual page 45

Resume by USB (S3) (Disabled)
This option allows the activity of the USB devices to wake up the system from S3 sleep
state.
VGA (OFF)
Use this item to enable power management unit to monitor VGA activities.
LPT & COM (LPT/COM)
Use this item to enable power management unit to monitor LPT or COM activities.
HDD & FDD (ON)
Use this item to enable power management unit to monitor HDD or FDD activities.
PCI Master (OFF)
This item enable or disable that the system will be waken up by PCI master command.
Resume by PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of the specified hardware peripheral or component is detected.
Resume by Ring (Disabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of WOL/WOM/Ring device is detected.
RTC Alarm Resume (Disabled)
When set to Enabled, additional fields become available and you can set the date (day of
the month), hour, minute and second to turn on your system. When set to 0 (zero) for
the day of the month, the alarm will power on your system every day at the specified
time.
• Date of Month: Use this item to define the date of month when using the RTC
alarm to resume the system.
• Resume Time (hh:mm:ss): Use this item to define the time when using the
RTC alarm to resume the system.
Press <Esc> to return to the Power Management Setup screen.
Using BIOS
39