Positioning The Charging Station - Siemens SICHARGE UC 150 Operating Instructions Manual

SICHARGE | Operating Instructions

5.3 Positioning the charging station

To set up the charging station at the site, you need to lift the charging station from the transport pallet. Then, use a forklift to
transport the charging station to the prepared base area.
Lifting the charging station
To lift the charging station from the transport pallet, proceed as follows:
1. Drive the forks from the front or from behind under the bottom of the cabinet.
2. Lift the charging station vertically upwards.
3. Transport the charging station in a vertical position in relation to the base area.
4. Reinstall the forklift covers on the bottom of the cabinet.
Positioning the charging station on the base area
To position the charging station on the base area, proceed as follows:
1. Position the charging station on the base area above the holes for the fastening screws.
2. Check that the mounting holes in the feet of the station are above the securing points on the base area.
3. Lower the charging station onto the base area.
5.4 Inserting the connecting cable into the cabinet
After positioning the charging station on the base for the first time, insert the power supply cable from below into the input
side of the charging station.
WARNING
Danger to life when standing under lifted loads
If hoisting gear or load handling equipment fail, a lifted load can drop. If you are in the hazardous area
under or next to the lifted load at this time, death, serious injury, and material damage may result.
• Always use hoisting gear and load handling equipment properly.
• Do not stay in the hazardous area under or next to lifted loads.
DANGER
Danger to life due to improper lifting
If you lift the charging station improperly, the device may tip over. Tipping of the charging station can
cause death, serious injury, and material damage.
• Only qualified personnel should lift the charging station.
• Only use approved hoisting gear.
• Pay attention to the center of gravity of the charging station.
• Note the weight of the charging station.
• Only lift the charging station in a vertical position.
• The forks of the forklift must protrude on the opposite side of the charging station.
34