Emergency Stop Button - Siemens SICHARGE UC 150 Operating Instructions Manual

Prepare to switch on again after work is finished
After finishing and checking the work, prepare the restart as follows:
• Inform persons no longer required that the work is completed and no further work is permitted
• Withdraw persons no longer required
• Remove all tools, equipment, and aids used
Switch on the electrical system again
After finishing the work, remove the protective measures and switch the system on again:
1. Remove the short circuit
2. Remove the grounding
3. Remove the covers or barriers
4. Remove the fuse to prevent restarts
5. Switch the system back on
2.3

Emergency Stop button

In a hazardous situation, pressing the Emergency Stop button immediately puts the charging station into the safe
Emergency Stop state.
Position of the button
The Emergency Stop button is positioned on the front of the charging station in the middle of the right-hand device door.
a Emergency Stop button
Figure 2-1 Position of the button
Function of the Emergency Stop button
Pressing the Emergency Stop button triggers an alarm and immediately puts the charging station into the safe Emergency
Stop state. This state stops the charging process immediately and prevents charging from starting.
The Emergency Stop button does not interrupt the infeed to the charging station. Ensure the electrical isolation of the
supply line to the charging station before opening the control cabinet door.
For safety reasons, the charging station is not operable in the Emergency Stop state. The charging station only returns to its
normal operating state after the button has been reset.
Operating Instructions | SICHARGE
13