Table of Contents
Advertisement
Optional Equipment
Installation de retour de flamme
ATTENTION:
Coupez
l'alimentation en gaz de
l'appareil et assurez-
vous qu'il est
complètement refroidi
avant d'effectuer
l'entretien.
1
Enlevez le cadre de
verre et les bûches.
2
Installez les plaques de
cheminée en suivant les
instructions à droite
(remarque: la plaque de
foyer est jetée).
Travis Industries
(for qualified installers only)
Remove and discard
the hearth plate
b
Remove the exhaust restrictor
(4 screws hold it in place).
a
Remove the rear burner.
NOTE: when replacing make sure the
burner is properly aligned and the holes on
the tabs on the burner insert over the pins
on the burner stand.
Remove the clips on both sides (these clips have key-
a
holes, allowing removal without removing the screw)
5/16" Nutdriver
d
Place the floor
firebacks in place.
4161122
Remove the rear air deflector
c
(two screws hold it in place).
Remove the screw holding
d
the accent light assemblies in
place. Re-position the
assemblies so they are laying
flat, this allows the rear
fireback to install.
Place the rear fireback in place. The side
b
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Place the side firebacks
c
in place. Secure using
the screws and clips
removed in step "a".
63
100-01387
Advertisement
Table of Contents
