Table of Contents
Advertisement
The X-Window selection screen will appear.
The settings displayed on the top line (followed by C:) indicates
the current settings.
The } mark on the upper right corner indicates that the other
settings than displayed on the screen are pre-installed. Use
{ } to scroll the screen to show the other settings.
Press C to return to the initial Rapid WINDOW.
4. Press 5 E to select
X < 1 scl = 1.
The Y-Window selection screen will appear.
The settings displayed on the top line (followed by C:) indicates
the current settings.
If you select A AUTO, the Y settings are set to the corresponding
settings to X settings.
5. Press 4 E to select
< 1 scl = 1.
6. Press E to draw the graph.
7. Press @ q to return to the calculation screen.
If you press C during the settings and the X-Window settings
Note:
are completed, the settings affect the subsequent operation. (It is
not required to set both the X- and Y-Window settings at once.)
Chapter 4: Graphing Features
-
10 <
-
10 < Y
87
Advertisement
Table of Contents
