Table of Contents
Advertisement
About the Insert
mode
Tips:
Chapter 2: Operating the Graphing Calculator
When the editing mode is set to one-line, insert mode needs to
be manually specified. Press and release @, then i to
set the insert mode. Press @ i again to return to the
overwrite mode.
The C key clears all screen entries in the Calculation screen,
as well as clearing error messages. It also clears a single line
equation in the Y screen. For more information on the Y
key, refer to Chapters 4 of the manual.
Example
Type 3096, then change 3 to 4. When done, move the cursor to
the very end of the numbers.
# C 3 0 9 6 ; ;
; ; D 4 ' '
'
Example
Type 4500000, then remove 500.
# C 4 5 0 0 0 0 0 ; ;
; B B B
You can jump the cursor to the beginning or the end of line by
using the @ and ; ' keys. Likewise, if the cursor is
at the very top of the stacked entry, press @ } to jump
the cursor all the way to the bottom. Press @ { to jump
the cursor to the top. To learn about how to use the @ key
and its functions, refer to the section "Second Function Key" of
this chapter.
15
Advertisement
Table of Contents
