Table of Contents
Advertisement
Execute the
program
2. Programming Hints
Editing the
program
Adding com-
mands, strings
or command
lines to the
program
Entering
alphabetical
characters
(uppercase
only)
Inputting
commands
Storing a
program line by
line
Blank line
Deleting a line
Deleting
command or
strings
14. Press P A.
A list of stored programs will
appear.
15. Press 0 1 to execute the
program 01 "HELLO".
Press P B and then the appropriate numbers to open
the stored program.
Press @ i to enter the insert type mode.
Press E to go to the next line. Be sure to press @ i
again to turn off the insert type mode and return to type over
mode.
Press E twice to insert a blank line.
Press A to enter characters. Press @ . to use a
ALPHA-LOCK mode to input a series of alphabetical characters.
In general, only a single command can be input per line.
After pressing E, } or {, the line will be stored in
memory. Otherwise, it is not stored. Be sure to store the all lines
by pressing E ({ or }) before quitting editing
(pressing @ q).
Blank lines are ignored during execution. You can include blank
lines to gain better readability.
Move the cursor to the line you wish to delete and press C.
Move the cursor to on or after the letter you wish to delete and
press D or B, respectively.
Chapter 9: Programming Features
141
Advertisement
Table of Contents
