Electrical Power Connections; Motor Rotation - Jackson DISHSTAR HT-E Installation, Operation And Service Manual

INSTALLATION
ELECTRICAL POWER
CONNECTIONS
Disconnect electrical
power at the breaker or
disconnect switch and
tag-out in accordance with
procedures and codes.
On 460 V machine,
imbalanced wild leg
goes to L3.

MOTOR ROTATION

i
!
CAUTION
CAUTION! On 3-Phase
machines only, correct
pump motor rotation
must be verified
before operation!
07610-004-43-79-Q
Electrical and grounding conductors must comply with the applicable portions of the
National Electric Code ANSI/NFPA 70 (latest edition) and/or other electrical codes.
The data plate is located on the left-front of the dishmachine. Refer to the data plate for
machine operating requirements, machine voltage, total amperage, and serial number.
Remove the back panel and set aside. Remove the terminal block box cover. Install
3/4" conduit into the hole in the bottom of the terminal block box. Route power wires and
connect to terminal block. Install the grounding wire onto the lug provided. "DE-OX" or
another similar anti-oxidation agent should be used on all power connections.
208/230 V
On 3-Phase machines only, correct pump motor rotation must be verified before
machine is operated. Failure to do so can result in damage to machine and
components.
1. Follow Filling the Wash Tub section.
2. Using a 7/16 nutdriver, remove front kick panel and keep hardware. Using a
phillips screwdriver, remove right dress panel and keep hardware. Leave start
switch wires connected.
3. Locate wash pump motor and identify arrow decal which shows correct motor
rotation.
4. Press Start button on right dress panel and immediately open door.
5. This will stop the cycle. Observe rotation of motor fan.
6. If incorrect, disconnect electrical power and reverse L1 and L2 connections at
terminal block shown in section above. Replace panels.
INSTRUCTIONS
L1 N
Ground
Wash Pump Motor
460 V
3Φ
L1 L2 L3
Ground
Arrow Decal
Motor Fan
9