Steam Line Connection; Electrical Power Connections - Jackson RackStar Series Installation, Operation & Service Manual

INSTALLATION
STEAM LINE
CONNECTION

i
ELECTRICAL
POWER
CONNECTIONS
Disconnect electrical
power at the breaker
or disconnect switch
and tag-out in
accordance with
procedures and codes.
i
!
CAUTION
07610-004-33-05-E
The steam machines come with lines to connect the source steam. Connect all steam
lines to the machine as all applicable codes provide. See machine data plate for
information concerning steam flow pressure.
Click here for the Steam Booster manual.
All electrical connections must be made in accordance with applicable portions of local,
state, territorial, and national codes.
Refer to the data plate for machine operating requirements, machine voltage, total
amperage and serial number.
1. Locate main power terminal blocks (for the machine and for the rinse booster
heater, for dual-point, one block for single-point) at the top of the machine.
2. Remove top cover to access terminal blocks.
3. Route incoming power lines within conduit that will connect via fittings to the pre-
punched holes in the back of the control box.
4. Install power and ground wires to lugs as indicated by the appropriate decals in the
control box. Use copper conductors only. Use of an anti-oxidation agent is
permissible on the power connections.
3Φ
Ground
5. Tighten all connections.
6. Verify incoming voltage matches the voltage indicated on the decal next to the
incoming power pre-punched hole.
For dual-point connection, machine has a separate power connection from
NOTICE
the rinse booster heater and the circuit protection requirements are different
for each. Refer to the machine data plate for information on minimum circuit
protection.
CAUTION! Improperly connecting external devices can cause damage to the machine
and/or electrical infrastructure! See the External Device Wiring section.
INSTRUCTIONS
3Φ
Ground
3Φ
NOTICE
Imbalanced
wild leg goes
to L3.
21