Table of Contents
Advertisement
5. Whilst another person holds the Console (5) near the
Upright (2) as shown, connect the wire harness on the
Console to the Upper Wire Harness (86). Insert the
excess wire harness into the Upright.
Attach the Console (5) to the Upright (2) with four M4
x 16mm Screws (66). Be careful to avoid pinching
the wire harnesses.
6. Whilst another person holds the Upright (2) in the
position shown, connect the Upper Wire Harness (86)
to the Lower Wire Harness (87). Insert the excess wire
harness into the Upright, and then insert the Upright
into the Frame (1). Do not pinch the Wire
Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer
(83) onto an M10 x 85mm Button Screw (63). Insert
the Button Screw into the Frame (1) and the Upright
(2). Make sure that the concave end of the Frame
Spacer is turned toward the Frame. Do not tighten
the Button Screw yet.
7. Identify the Left Pedal (13). Attach the Left Pedal to a
Spring Arm (14) with an M10 x 35mm Carriage Bolt
(121), an M10 Washer (119), an M10 Split Washer
(70), and an Adjustment Knob (38). Attach the Right
Pedal (not shown) to the other Spring Arm (not shown)
in the same way.
Next, attach a Handlebar Leg (79) and a Pedal Arm
Wheel (29) to the left Spring Arm (14) with a Bolt Set
(27). Attach the other Handlebar Leg (not shown) and
the other Pedal Arm Wheel (not shown) to the right
Spring Arm (not shown) in the same way.
8. Apply a thin film of grease to the Left Crank Arm (36)
in the indicated location.
Slide a Spring Spacer (117), the left Spring Arm (14),
and a Large Wave Washer (123) onto the Left Crank
Arm (36). Attach the left Spring Arm with an M8 x
19mm Patch Screw (108) and an M8 x 32mm Washer
(122).
Attach the other Spring Spacer (not shown) and the
right Spring Arm (not shown) to the right side of the
elliptical crosstrainer in the same way.
All manuals and user guides at all-guides.com
6
5
5
86
Console
Wire Harness
2
66
6
2
86
1
7
121
79
27
29
119
27
38
8
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
87
83
70
63
13
14
70
Grease
36
14
117
123
108
122
Advertisement
Table of Contents
