Led Display Operation - Dimplex DCMFBHSH Instruction Manual

Operation

LED DISPLAY OPERATION

Some functions can be operated by pressing the LED Display. To have full use of
all functions, please use the remote control.
1. Hold fan body with one hand and set the
wind outlet to the desired angle.
2. Turn the fan On by pressing the LED Display
screen for 1 second until you hear 1 beep.
The fan will start working in the previous
settings. To turn the fan off, press and hold
the LED display screen for 2 seconds until
2 beeps sound.
3. When the fan is already on, press the LED Display for 1 second to start
oscillation - 1 beep will sound. To stop oscillation, press the LED display for
1 second and the fan will beep once and stop oscillating.
4. To adjust the fan speed, briefly touch the LED Display to cycle through the
desired speed settings (1 to 9), a beep will sound for every speed change.
The speed setting will display on the screen.
FILTER
This purifying bladeless fan comes equipped with a HEPA-11 Filter which traps
99.97% of airborne allergens, pollutants, bacteria and gases. Please follow the
steps below to install/replace the air filter.
1. Turn the filter system top cover counter-clockwise to unlock the
2. Connect or disconnect the filter from the top cover by gently
3. After assembling, put back into the filter chamber and secure
10
filter chamber.
pulling the white cover from the filter
by turning the top cover clockwise.
15° 15°