Advertisement
Operation
1. Connect the plug to a power supply and switch on the power.
2. Switch the fan ON by rotating the speed switch knob at the rear in clockwise
direction. This switch is also used to adjust the fan SPEED.
3. The airflow direction can be adjusted upward/downward by simply lifting the
motor unit or rear guard UP or DOWN.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
fingers through the guard.
4. Turn the speed control switch to your desired fan speed by selecting HIGH (III),
MEDIUM (II) or LOW (I).
5. Oscillation - To activate the oscillation function, push down the oscillation knob
(9). Pull the oscillation knob (9) up to stop oscillation at the desired direction of
airflow.
6. Turn the dial to the (0) position to switch the fan OFF.
Cleaning
Over time, dust can accumulate on the grille covers and fan blades, which can affect
the fans performance. It is recommended to clean the fan at least once a month.
1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Lightly run a vacuum cleaner nozzle (soft brush) over the front and rear grilles to
remove any dust or dirt that may have accumulated inside or on the unit.
3. Remove any dust build up with a soft brush or cloth.
4. To remove stains from the blades, or for thorough cleaning before storage, open
the clips at the edge of the grilles, remove the tiny screw and nut at the bottom
of the grille edge and take off the grilles. Remove the blades cautiously for
cleaning, taking care not to drop them, then refit. Make sure all grille clips are
securely closed and the screw and nut tightened before reuse.
Do NOT use abrasive sponges, scouring pads, or a stiff brush to clean the unit.
IMPORTANT
The control panel and other parts must not come into contact with water or any
other liquids.
8
Advertisement
