Page 1
INSTRUCTION MANUAL 2.5L Misting Fan Model: DCMIST25 For domestic household use only.
Page 2
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your Misting Fan for the first time and keep them in a safe place.
Page 3
• DO NOT use the unit near windows or where water collects. Rain and water collection may lead to a risk of fire or electric shock. • Only operate this appliance with a minimum of 50cm clearance all around i.e. away from walls, furniture and overhanging objects such as curtains or a shelf.
Page 4
Exposed to the Near water If the power cable weather outdoors wires are frayed or cut Where small children If an extension Where the power may be left unattended lead may become cable may be overloaded damaged On a slope or Where there is risk Where it may be uneven surface...
Specification Model no. DCMIST25 Colour Grey/White Power supply 220-240V~ 50Hz Rated power Speed settings Modes 3 (natural, normal & sleep) Blade diameter 300mm Water tank capacity 2.5L Remote control Timer 0-8 hours Swing function 360° rotating grill Controls Button with LED display Max.
Page 6
Parts Remote Air Guide Grille Louvre Mist disk Blade Water tank Front case Rear case Base Castor...
Functions Before first use, remove any packaging and tape stuck on the unit. Paper ON/OFF tube After connecting the cord to a power outlet press the ON/OFF button to turn the unit ON. To turn the unit OFF press this button again. FAN SPEED The unit has 4 FAN SPEEDS and is adjusted from the lowest speed to the highest speed.
Functions MIST To activate the MIST function, press the MIST button once to turn on. Ensure there is enough water in the water tank. The LED indicator light will illuminate once activated. Press this button again to turn off the MIST function, and to use as a fan only.
Filling the water tank Filling the water tank: Place the unit on a flat surface and fill the water tank according to the following 3 steps. Press water tank button and remove the tank. Turn the water tank upside down and unscrew the cap. Fill the tank with clean cold filtered water.
Operation & Set Up 1. Remove the unit from its packaging & place on a firm stable surface. 2. To use the MIST function, fill the water tank as instructed on the previous page. 3. Plug into a power outlet and press the ON/OFF button to turn ON the unit. 4.
Page 12
Cleaning Due to the nature of the product, the unit should be cleaned regularly. Always turn the unit OFF and disconnect from the power supply before commencing any cleaning. De-calcifying the water tank In areas with hard water, deposits will build up, so it is recommended to de-calcify the unit every six months.
Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below. Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd 1340 Ferntree Gully Road, 38 Harris Road, East Tamaki,...