Advertisement
Parts
2. Grub screw
4. Rear grille
screws
1. Front grille
16. Safety screw
3. Fan blade
Rotary switch speed settings (9)
6
6. Motor shaft
7. Oscillation On/
Off switch
8. Fan motor
9. Rotary switch
10. Motor fixing hole
11. Adjustable pipe fixing
hole & long bolt & washer.
5. Rear grille
12. Adjustable pipe
13. Pipe base cover
15. 19mm bolt & washer
Oscillation On/Off button (7)
Assembly
1. Assemble the base (14) to the adjustable pipe (12) by holding the base on it's
side, and inserting the pipe into the centre. Secure the pipe (12) to the base (14)
with the supplied 19mm bolt & washer (15). Firmly tighten with a 19mm spanner
(not supplied).
2. To assemble the fan motor (8) to the adjustable pipe (12) locate the motor fixing
hole (10) and align with the adjustable pipe fixing hole (11). To secure the fan
motor to the adjustable pipe, use the long bolt & washer (supplied) and push
through the hole. Tighten the bolt well.
3. Align the rear grille (5) to motor shaft (6) on the fan motor (8) and ensure the
hole for the safety screw is at the bottom. The 4 screw holes on the front of the
fan motor (8) should line up. Firmly tighten all four rear grille screws (4).
4. Once the rear grille (5) is attached to the fan motor (8), turn the motor shaft
(6) so the flat area is at the top. Slide the fan blade (3) all the way onto the
motor shaft (6) and firmly tighten the grub screw (2) by rotating in a clockwise
direction.
5. Once the fan blade is fixed, align the top locking clip on the front grille (1) so it
fixes to the that of the rear grille (5). Lock the side and bottom clips in place.
TIP: the logo should be horizontal. Secure the front & rear grille, by inserting and
fixing the safety screw (16) and nut.
Operation
14. Base
1. Ensure the rotary switch (9) is in the '0' position, prior to connecting the plug to
the power supply.
2. Switch the fan ON by rotating the rotary switch (9) on the back of the fan motor
(8) to the desired setting - 1, 2 or 3. Turn to the '0' position to turn OFF.
3. To start oscillation, press the oscillation On/Off switch (7) to the 'I' position. To
turn oscillation off, press to 'O' position.
4. The airflow direction can be adjusted upward/downward by lifting up or pressing
down the motor housing.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
fingers through the guard.
7
Advertisement
