Advertisement
Assembly
1. Remove the fan assembly and parts from the packaging.
2. Position the V-shaped fan stand on the floor and slide the tubes extending from
the fan assembly into the V-shaped fan stand. Push tubes down until the spring
loaded button protrudes through the holes and locks into place (refer Fig. 1)
3. Ensure that fan assembly is positioned on the V-shaped stand as shown in Fig. 1
Operation
1. Ensure the fan is positioned on a dry and level surface. Connect the plug to a
power supply and switch on the power.
2. Switch the fan ON by rotating the speed switch at the rear in clockwise direction.
This switch is also used to adjust the fan SPEED.
3. Turn the speed control switch (Fig. 2) repeatedly to adjust the fan SPEED from
LOW "1" - MEDIUM "2"- HIGH "3" in sequence.
4. The airflow direction can be adjusted upward/downward by simply tilting the fan
head UP or DOWN.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
fingers through the guard.
5. Turn the switch anti-clockwise back around to "0" to turn the fan OFF.
Instruction Manual - 40cm HV Floor Fan DCFF40HV v1.indd 7
Instruction Manual - 40cm HV Floor Fan DCFF40HV v1.indd 7
Fig. 1
7
20/09/2021 11:21:52 AM
20/09/2021 11:21:52 AM
Advertisement
