Avery Dennison Monarch 9864 Quick Reference Manual page 23

06/08 Rev. AA
5. Return the printhead mounting to its original position and tighten the thumb
6. Connect the printhead cable.
7. Connect the power supply and turn on the printer.
1. Turn off the printer and disconnect the power supply.
2. Remove he material and ribbon.
3. Remove the pull-out module (left side).
4. Moisten a lint-free cloth with isopropyl alcohol and wipe the feed roller
5. Replace the pull-out module.
QUICK REFERENCE
screws.
Press the thumb screw on the tapered edge of the square axle and ensure
the exact positioning of the printhead mounting on the axle. Also pay
attention to the position of the printhead in relation to the edge of the label.
The printhead should be flush against the inner black plastic plug.
Cleaning the dispenser-feed roller
Dispensor version only!
Fig. 5 Left side: remove the pull-out module; right side: cleaning the dispenser-feed-roller
using isopropyl alcohol.
clean. Turn the roller with your finger to clean the entire surface.
9864
21