Table of Contents
Advertisement
06/08 Rev. AA
6. Return the printhead mounting to its original position and tighten the thumb
7. Connect the printhead cable before turning on the printer.
1. Turn off the printer and disconnect the power supply.
2. Remove the material and ribbon.
3. Remove the printhead.
4. Moisten a lint-free cloth with isopropyl alcohol and wipe the feed roller
QUICK REFERENCE
CAUTION! - Only clean the print roller with a lint-free cloth. Do not use
sharp objects to clean the rollers!
screws.
Press the thumb screw on the tapered edge of the square axle and ensure
the exact positioning of the printhead mounting on the axle. Also pay
attention to the position of the printhead in relation to the edge of the label.
The printhead should be flush against the inner black plastic plug.
Cleaning the feed roller
Clean the feed roller when you adhesive buildup or dirt on the roller.
clean. Turn the roller with your finger to make sure it is clean all the way
around.
Shift the front material guiding (1) and the contact pressure rollers (2) for
better access to the roller.
Fig. 4 To clean the feed roller, remove
the printhead and shift material
guiding (1) and set the contact
pressure rollers (2) aside.
9864
2
1
20
Advertisement
Table of Contents
