Motorola M68MPB334 User Manual page 21

4. Connect one end of the 01-RE90341W01 REV 0 active probe cable to
The active probe is now ready to connect to the target system (refer to the PPB
configuration guide for information on connecting the active probe to the target
system.)
Figure 2-3. Active Probe Interconnection (with Active Probe Box)
M68MPB334UM/D
connector P6 on the MMDS control board; connect the other end to
connector J6 on the TCB. Connect one end of the 01-RE90340W01 REV
0 active probe cable to connector P5 on the MMDS control board; connect
the other end to connector J5 on the TCB. Secure the connector clamps on
TCB connectors J5 and J6.
HARDWARE PREPARATION AND INSTALLATION
2-11