Table of Contents
Advertisement
MEVB QUICK START GUIDE
3.2.2
MPFB Jumper Headers
Configure your MPFB jumper headers per the instructions in Table 3-1. Table 3-1
contains information exclusively intended for quick start and ignores the other
jumper headers.
Table 3-1. MPFB Quick Start Jumper Header Configuration
Jumper
Header
Type
W2
1 2 3
W3
1 2 3
W4
1 2 3
W5
1 2 3
W10
1
2
3
4
5
6
1
2
W12
3
4
5
6
7
8
9
10
W14
1 2 3
W16
1 2
W17
1 2
3-2
Install a jumper on pins 1 and 2 to configure pin 1 of the memory devices in the
pseudo ROM sockets (U2 & U4) as a standard address line.
Install a jumper on pins 1 and 2 to indicate that the memory devices in the
pseudo ROM sockets (U2 & U4) have 28 pins.
Install a jumper on pins 1 and 2 to set the pseudo ROM port size (memory data
width) as word.
Install a jumper on pins 1 and 2 to disable the PRU.
Install a jumper on pins 1 and 2 to indicate that RAM is installed in the pseudo
ROM sockets (U2 & U4).
Install a jumper on pins 3 and 4 to indicate that the two devices installed in the
pseudo ROM sockets (U2 & U4) are 32K x 8.
Jumper header W14 selects the MCU signal for the memory devices in the fast
RAM sockets (U9 & U10) and pseudo ROM sockets (U2 & U4). Pins 1 and 2
select the MCU chip select for the memory devices in the fast RAM sockets.
Pins 2 and 3 of jumper header W14 select the chip select for the memory
devices in the pseudo ROM sockets.
Jumper installed on CSBOOT pins 2 and 3 (factory default); use CSBOOT as
the memory device chip enable for memory devices in the pseudo ROM
sockets.
No jumper installed; the MCU MODCLK signal is pulled high (logic 1) via a
resistor during reset.
No jumper installed; the BERR signal is pulled high (logic 1) via a resistor
during reset.
Description
M68MPB334UM/D
Advertisement
Table of Contents
