Removal Of The; Removal Of The Rear Cover - Barco XDX Series Installation Manual

Projector covers
7.1 Removal of the front cover
If the front cover is the only cover you need to remove (e.g. when checking / replacing the filter),
there is no need to turn off the projector.
Required tools
Allen wrench 4 mm
How to remove
1. Unlock the safety bracket on the side of the projector. Use a 4 mm Allen wrench to remove the two hex
screws locking the bracket (reference 1).
1
Image 7–1
2. Rotate and move the bracket to a position it won't hinder you while removing the front cover.
3. Slide the front cover to the side of the Input & Communication Unit towards the frame bar (reference 2)
and remove it (reference 3).
Note: The handles do not click open. They are fixed into the cover.
Image 7–2 Sliding the front cover towards the frame bar and removing it.

7.2 Removal of the rear cover

If the rear cover is the only cover you need to remove (e.g. when checking / replacing the filter),
there is no need to turn off the projector.
72 R5914481 /02 XDX