Using A Tripod; Attaching The Connector Cover - Canon CR-X300 User Manual


Ceiling Mount
Do not use the screw holes for tripod but use the mounting bracket to install the camera.
When installing the product outdoors using a pole, etc., to prevent rain and bird damage, prepare mounting brackets
of  290 ± 5 mm (mounting brackets of larger than  300 mm will be captured) matching the dimensions of the four
M6 taps on the bottom surface.
The logo plate can be turned upside-down. Pull up gently the right and left sides of the logo plate to pull it out, rotate
it and push it back into place.

Using a Tripod

Attach the tripod by fixing a screw to the screw hole for tripod.
Use 1/4-20UNC screws and tighten them securely, and set the tripod on a flat surface with no steps.

Attaching the Connector Cover

(4)

Preparation before Attaching
• Thread each cable through the connector cover (1).
• Connect each cable to each connector on the receptacle unit. Make sure that the cables are securely attached so
that they will not come off. Use a cable clamp for the power cable (P. 15). For HDMI cable, if necessary, use a
cable retaining part to take measures to prevent it from disconnecting.
• If not using an IP connection, configure the control protocol.
• Take necessary measures against lightning damage.
1/4-20UNC
(3) (2) (1)
21
5 6 mm