Table of Contents
Advertisement
Note
Even if the video is inverted, the position of the tilt slider will not be inverted, which makes the video and the slider move in the opposite
direction.
Color Bars
Sets the types of color bars.
When outputting the color bars, set [Other Functions] > [Color bars] to [On].
[Color Bar Type]
Select either SMPTE compliant, EBU compliant, or ARIB compliant.
AUX OUT
Settings for output operation to external devices.
When outputting to an external device, set [Other Functions] > [AUX OUT] to [On].
[Operation Mode]
Select whether the contact of the output terminal is normally open or close.
If set to [Normally Open], when the contact of the output terminal is closed, an active event occurs, and inactive event
occurs when it is opened.
If set to [Normally Close], when the contact of the output terminal is opened, an active event occurs, and inactive event
occurs when it is closed.
Normally Open
Active event status
Inactive event status
Normally Close
Inactive event status
Active event status
Tally Lamp
Settings for the tally lamp.
[Tally Lamp Control]
Select whether to use tally lamp control.
[Tally Lamp Brightness]
Select the brightness of the tally lamp when [Tally Lamp Control] is set to [Enable].
Genlock
Genlock enables to synchronize the video signals between the camera and the external video device.
Use the GEN-LOCK terminal to input external sync signals (analog black burst signal or HD ternary signal) to the camera.
[Genlock]
Select whether to use Genlock.
[Genlock Adjustment]
Adjusts the H phase of the genlock in the range of approximately ±0.4 H around the phase difference 0.
Note
• When a synchronizable Genlock signal is inputted, synchronization will stabilize after approximately 10 seconds.
• If an incorrect Genlock signal is inputted, synchronization may not be stable.
1 (contact closed)
0 (contact open)
1 (contact closed)
0 (contact open)
76
Advertisement
Table of Contents
