Changing The Fuse Of The Fuel Pump - KTM 450 SX-F FACTORY EDITION Owner's Manual

14.5

Changing the fuse of the fuel pump

Warning
Fire hazard Incorrect fuses overload the electrical system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Info
The fuel pump is protected by the fuel pump fuse. This is located under the seat.
Main work
–
Pull starter relay
F03751-10
–
Take off protection caps
–
Remove faulty main fuse
Info
A faulty fuse has a burned-out fuse wire
A spare fuse
–
Insert a new main fuse.
Fuse (58011109110) (
–
Check that the electrical system is functioning properly.
Tip
Insert a spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and route the cable.
F03752-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
Preparatory work
–
Remove the seat. (
ELECTRICAL SYSTEM 14
1
from the holder.
2
.
3
.
4
is located in the starter relay.
p. 133)
( p. 70)
p. 62)
p. 61)
A
.
103