12 BRAKE SYSTEM
92
–
Manually press the brake caliper toward the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir; extract some if necessary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake piston.
–
Remove cotter pins
brake linings.
F03721-10
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
sliding plate
rectly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
F03722-10
–
Insert the new brake linings, insert pin
4
pins
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
F03723-10
point.
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
H05051-10
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten the screw
Guideline
Screw, frame protec-
tor
–
Mount the new cable ties.
H05050-11
4
5
, pull out pin
, and remove the
6
in the brake caliper and brake pad
7
in the brake caliper bracket are seated cor-
5
8
A
.
p. 138)
2
with membrane
1
and washer.
M5
, and mount cotter
is mounted on the
3
and the
3 Nm (2.2 lbf ft)