JVC 250 Service Manual page 50

19. Retighten the two wing nuts and tighten the two hex nuts.
20. Reset the ILA
®
ILA Back Focus Adjustment
®
The ILA Back Focus adjustment moves the ILA
forward or backward as one unit to focus the ILA
using a zoom lens this adjustment allows the zoom lens' tracking to remain
focused on the screen throughout the entire zoom range. Use the Focus Pattern
(Test Pattern #6) to perform this adjustment one color at a time. The procedures
below perform the ILA
a zoom lens. The second procedure is for a fixed lens.
For best results, perform ILA
person to stand in front of the screen to observe Spacer Balls and the other to
move the ILA
adjustment, but may need some touch-up in the field.
Tools Needed
4-mm Hex wrench
2.5-mm Hex wrench
Parts Needed
No parts are needed
To adjust the ILA
1. Power the projector ON and allow to stabilize for at least 15 minutes
2. Remove the Rear Cover and tilt up the Electronic Module.
3. Hide Red and Blue. View Green.
4. Select the Focus Pattern (Test Pattern #6).
5. Select Projection Lens from the menu.
6. Use the up/down arrow keys to zoom the Projection Lens to full telephoto
position (smallest image).
7. Use left and right arrows to focus the projection lens to get sharply
focused spacer balls.
NOTE: Spacer balls separate the layers inside the ILA
are tiny, random, irregularly shaped spots that are visible throughout the
image. Stand directly in front of the screen and look in the lighter areas of
the image to see the Spacer balls. From throw distances shorter than 4
meters, spacer balls are difficult to see.
8. Zoom the lens to a wide-angle position (largest image).
9. Loosen the wing nut on the Green Relay Lens (or whichever lens is being
focused).
Model 250 Service Manual
®
biases to their previous levels from Step 2.
®
Back Focus for the Green lens. The first procedure is for
®
Back Focus procedure with two people: One
®
/Relay Lens/CRT assemblies back and forth. This is a factory-set
®
Back Focus for a Zoom Lens:
Chapter 4---Optical
®
/Relay Lens/CRT assemblies
®
output on the screen. When
®
Assembly. They
4-17