Optical Path - JVC 250 Service Manual

4.0 Optical
Contents
4.1 Arc Lamp...................................................................................................... 4-2
4.2 Optical Path .................................................................................................. 4-7
®
4.3 ILA ............................................................................................................. 4-13
4.4 Relay Lenses ................................................................................................ 4-20
4.5 Projection Lens............................................................................................. 4-20
CAUTION!
review the chapter on Safety at the beginning of this manual.
WARNING!!!
that require projector covers to be off, wear high voltage gloves
(ANSI/ASTM 10,000 volt rated) when working near the CRTs, Arc Lamp,
or power supplies. Wear safety goggles (rated X5) when working
anywhere near the light path from the arc lamp or the projection lens.
Dangerous levels of ultraviolet and infrared radiation, dangerous glare, very high
temperatures (180°C to 300°C) and high internal gas pressure are present at the
Xenon Arc Lamp. The lamp is contained in a protective reflector-housing module
and should not be operated outside this housing or outside of the projector.
When replacing the Arc Lamp, replace it as an entire module, as shown in this
manual. Do not open the lamp housing or attempt to replace the Arc Lamp
inside its module! Do not touch the Arc Lamp, or any connections, when the
lamp is ignited or is arcing.
Any servicing of the Arc Lamp must remain restricted to Hughes-JVC Certified
Technicians.
Model 250 Service Manual
Before performing procedures in this chapter,
When performing procedures in this chapter
Chapter 4---Optical
4-1