Cleaning Lenses, Ila Assemblies, And Mirrors - JVC 250 Service Manual

The EMI Shield is a metal plate located in front of the Low Voltage Power
Supply and the Arc Lamp Power Supply. It must be removed before removing
either of these power supplies. Be sure to replace the EMI Shield after replacing
either the Low Voltage Power Supply or the Low Voltage Power Supply.
6.7 Cleaning Lenses, ILA
The projection lens is the only item that requires periodic cleaning. Other
assemblies are covered to prevent dust entering or finger smudging. Cleaning may
be needed for special circumstances such as replacing an assembly. Cleaning
should only require removing excessive dust (use canned air such as "Office
Duster" or "Aero Duster") or removing fingerprint smudges (use "Kodak Lens
paper", or equivalent) from the projection lens. As much as possible, clean the
optics only when absolutely necessary.
Projection Lens - Use lens paper and wipe the lens clean in a vertical motion from
top to bottom. Use compressed air to blow excess dust from the lens. An optical
lens cleaning solution can also be used to remove finger smudges.
®
ILA Assembly - Clean the ILA
not wipe the ILA assembly faces.
CRT Faces - Use compressed air to blow dust off and lens paper to clean face.
Relay Lens - Same as Projection Lens.
Mirrors and Polarizing Beam Splitter Windows - The Optical Shields cover the
Dichroic Mirror Assembly and Polarizing Beam Splitter windows. Normally
cleaning is not needed. Clean only if absolutely necessary using compressed air.
Do not wipe mirrors.
Model 250 Service Manual
Chapter 6---Miscellaneous Items
®
Assemblies and Mirrors
®
assembly faces with compressed air only. Do
6-5