Electrical Section - JVC 250 Service Manual

Chapter 2---System Description
Figure 2-1 Overview of the Model 250 projector showing major components

Electrical Section

2.2
The electrical section consists of the Incoming Power Circuit, and the Power
Supplies and the Igniter Assembly. The following paragraphs give a list of major
components and a brief description of those components. For a more detailed
description of a component, refer to the chapter and section dedicated to that
particular component.
Incoming Power Circuit
Power Cord - The AC power comes in through the Power Cord to the AC
!
Circuit Breaker.
AC Circuit Breaker - The Circuit Breaker connects and disconnects the
!
projector from electrical energy and protects the projector from over-
voltage conditions.
AC Line Filter - The AC SF Series Line Filter reduces radiation generated
!
by a regulated power supply from returning to the AC power source.
Power Supplies
Low Voltage Power Supply (LVPS) - The LVPS supplies standby
!
voltages and the main system voltages to the projector.
Arc Lamp Power Supply (ALPS) - The ALPS supplies power to the
!
Igniter Assembly while the Arc Lamp is lighting. After the Arc Lamp has
lit, ALPS provides the steady state power to the Arc Lamp. The ALPS
also monitors the condition of the Arc Lamp and sends a feedback signal
to the System Controller PCB if there is a problem.
High Voltage Power Supply (HVPS) - The HVPS provides the Anode,
!
Focus (G
for the CRT.
2-2
), Black Level (G ), Blanking (G
3 2
), and Dynamic Focus voltages
1
Model 250 Service Manual