Relay Lenses; Projection Lens - JVC 250 Service Manual

Chapter 4---Optical

4.4 Relay Lenses

The Relay Lens focuses the image light received from the CRT on the
photoconductive layer of the ILA
adjustments for the Relay Lens. The Relay Lens rarely needs service and is not
considered a serviceable part.

4.5 Projection Lens

Projection Lens - Input
Combined RGB image light from the Prism Assembly.
Projection Lens - Output
Output image light to the screen
Projection Lens - Operation
The projection lens receives image light from the Prism Assembly. The light is
high intensity light from the ILA
from the CRT. After leaving the ILA
the Prism Assembly where the red, green, and blue image light are combined. The
Projection Lens focuses this output image light onto the screen. All Projection
Lenses come with motorized focus adjustment.
The Model 250 projector comes with a choice of four standard lens options.
Motorized Zoom Lens
2:1 - 4:1
Fixed Lenses
!
0.96: 1
1.5: 1
5.6:1
Optional Lenses
!
2.4:1 Simulator Lens
Projection Lens - Service Adjustments
There are no service adjustments for the Projection Lens. The focus adjustment,
both rough and fine focus adjustments, are part of the projector setup procedure
(see Model 250 User's Guide, Setup Adjustments sections 5.4 and 5.5.15)
Projection Lens - Remove and Replace
Tools Needed
5-mm Hex wrench
To remove the Projection Lens:
1. Remove the sponge cover that is around the front of the Projection Lens.
2. Disconnect and label the Projection Lens Focus and Zoom motor cables
(The Focus motor is at the top of the Projection Lens. The Zoom motor is
at the bottom.)
4-20
®
(see Figure 4-9). There are no service
®
that has been modulated by the image light
®
s the modulated light travels back through
Model 250 Service Manual