Maintenance - Crown GLT-80 Installation & Operation Manual

Gas fired steam tilting
Table of Contents

Advertisement

Maintenance

Maintenance
Contact the factory, the factory representative or a local service company to perform maintenance and repairs.
Disconnect the power supply to the appliance before cleaning or servicing.
Daily
1. Wash exposed cleanable areas.
Monthly
1. Clean around burner air mixers, louvered panels and pilots if grease or lint have accumulated.
Twice a Year (minimum)
Have an authorized service person clean and adjust the unit for maximum performance.
It is NOT RECOMMENDED to use cleaning agents that are corrosive.
Use of cleaning agents that contain chloride, acids or salts are corrosive and may cause pitting and corrosion when used
over a period of time; this will reduce life of the appliance.
Should pitting or corrosion occur this is not covered by warranty.
Follow the recommended cleaning instructions. Use a mild detergent, warm water and rinse thoroughly.
Never spray water into electric controls.
Draw-off valve has a vulcanized rubber coated stem for better sealing. Do not over tighten. This may cause the
rubber to pull away from stem and permanently damage it. This is not covered under warranty.
12
PAGE
OF 32
NOTICE
WARNING
NOTICE
INSTALLATION & OPERATION MANUAL 10325 REV 1 (11/21)
Gas Fired Steam Tilting Kettles

Advertisement

Table of Contents
loading

This manual is also suitable for:

Glt-100

Table of Contents