Page 1
Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. CROWN FOOD SERVICE EQUIPMENT A Middleby Company 70 Oakdale Road, Downsview (Toronto) Ontario, Canada, M3N 1V9 Telephone: 919-762-1000 www.crownsteamgroup.com...
Self-Generating Steam Jacketed Tilting Kettle Table of Contents RETAIN THIS MANUAL FOR FUTURE REFERENCE. Table of Contents Important Notes For Installation and Operation ..............2 Service Connections ......................4 Introduction ........................... 5 Installation ..........................6 Operation ..........................7 Cleaning ..........................9 Appendix A, Material Safety Data Sheet ................
28.9 18.3 16.7 14.5 11.5 [111 kg] (0 mm) (76 mm) (184 mm) As continued product improvement is a policy of Crown, specifications are subject to changge without notice. PAGE OF 24 INSTALLATION & OPERATION MANUAL 10067 REV 8 (12/21)
Introduction Description Model EC-20T (20 gallon capacity) is an electrically powered, self-contained, tilting kettle. The appliance has a jacket of double-wall construction forming a sealed reservoir around the lower two-thirds of the kettle. The reservoir is charged with distilled water. Kettles are equipped with a “clean lock” to hold kettle in cooking position or 105 degrees for ease of cleaning, removable electric heating element and controls, and a low water cutoff device for protection of the heating elements.
Self-Generating Steam Jacketed Tilting Kettle NSTALLATION Installation NPACKING IMMEDIATELY INSPECT FOR SHIPPING DAMAGE Immediately after unpacking the steamer, check for possible shipping damage. If the steamer is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. Installation Instructions 1.
Self-Generating Steam Jacketed Tilting Kettle PERATION Operation Operating Instructions 1. Ensure that the external electrical service to kettle is on. 2. Check pressure gauge for correct cold kettle reading. Reading should be in the green vacuum zone (25 - 30 In. Hg or 635 - 762 mm Hg of vacuum).
Page 8
Self-Generating Steam Jacketed Tilting Kettle PERATION Venting Instructions Check vacuum/pressure gauge when kettle is cold. Gauge should be in the green vacuum zone (25 - 30 In. Hg or 635 - 762 mm Hg of vacuum). If not, air is present which must be vented (removed) for proper heating. Use the following procedures to vent air: 1.
Self-Generating Steam Jacketed Tilting Kettle Cleaning Cleaning WARNING Disconnect the power supply to the appliance before cleaning or servicing. WARNING Never spray water into electric controls or components! CAUTION The equipment and its parts are hot. Use care when operating, cleaning and servicing. CAUTION Do not use cleaning agents that are corrosive.
Page 10
Cleaning Self-Generating Steam Jacketed Tilting Kettle What To Do If Surface Rust Appears Metal utensils should never be used as they will scratch the surface of the equipment and rust may begin to form. To remove surface accumulation of rust from the inadvertent use of such utensils, the following procedure may be used. CAUTION Improper use of this procedure may damage your appliance! 1.
Page 24
STEAM JACKETED TILTING KETTLES A product with the Crown name incorporates the best in durability and low maintenance. We all recognize, however, that replacement parts and occasional professional service may be necessary to extend the useful life of this appliance.