Maintenance - Crown GL-20E Installation & Operation Manual

INSTALLATION AND OPERATION MANUAL, GAS KETTLES

5.0 MAINTENANCE

Contact the factory, the factory representative or a local service company to
perform maintenance and repairs.
WARNING: Disconnect the power supply to the appliance before
cleaning or servicing.
Daily:
1. Wash exposed cleanable areas.
Monthly:
1. Clean around burner air mixers, louvered panels and pilots if grease or lint have
accumulated.
TWICE A YEAR: (minimum)
Have an authorized service person clean and adjust the unit for maximum performance.
It is NOT RECOMMENDED to use cleaning agents that are corrosive.
Use of cleaning agents that contain chloride, acids or salts are corrosive and may cause pitting
and corrosion when used over a period of time; this will reduce life of the appliance.
Should pitting or corrosion occur this is not covered by warranty.
Follow the recommended cleaning instructions. Use a mild detergent, warm water and rinse
thoroughly.
Never spray water into electric controls.
NOTICE: Draw-off valve has a vulcanized rubber coated stem for better
sealing. Do not over tighten. This may cause the rubber to pull away from
stem and permanently damage it. This is not covered under warranty.
10125R4
Models GL-20E, GL-40E, GL-60E, GL-80E, GL-100E
18 2017-08-29