Table of Contents
Advertisement
RD-7505(A)_ENG_101115_RD-7505(A)_ENG 2010-11-16 오전 10:36 페이지 43
Continued
1.
Place the microphone on a flat level surface at the listening position.
• If possible, use a tripod, etc. to attach the microphone at the same height as your ears would be when you are seated in your
listening position.
• Ensure there are no obstacles between the speakers and the microphone.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "AUTO SET", then press the ENTER button.
• Loud test tones are output successively and then if a series of auto setup procedure has been completed, the results are
memorized and the previous menu is displayed.
• To stop the auto setup procedure while performing it, pess the AUDIO ASSIGN(/RETURN) button or the SETUP (/MAIN
MENU) button.
• If there may be a problem with front speakers or microphone connection, error message will be displayed. In this case, turn off
the power, check the connection and then retry the auto setup procedure.
• Check the results on each setup menu (CONFIGURATION menu on page 45, DISTANCE menu on page 47 and CH
LEVEL menu for "CAL" mode on page 48).
• If the results are not satisfactory, you can retry the auto setup procedure or personalize your speaker setup and channel
level setup by making the settings manually. (For details, refer to "When selecting the CONFIGURATION" on page 45,
"When selecting the CROSSOVER" on page 46, "When selecting the DISTANCE" on page 47, "Adjusting each channel level
with test tone" on page 23 and "Adjusting the current channel level" on page 24.)
■Notes :
• Because the test tones are loud, ensure there no infants or small children in the room.
• For best results, ensure the room is as quiet as possible during the auto setup procedure.
If there is too much ambient noise, the results may not be satisfactory.
All manuals and user guides at all-guides.com
43
Advertisement
Table of Contents
