Sherwood RD-7505 Operating Instructions Manual page 10

Hide thumbs Also See for RD-7505:
Table of Contents

Advertisement

RD-7505(A)_ENG_101115_RD-7505(A)_ENG 2010-11-16 오전 10:36 페이지 10
Continued
Connecting speaker wire
1. Strip away approx. 10 mm
(3/8 inch) of wire insulation,
then twist the wire ends
tight.
Speaker placement
Ideal speaker placement varies depending on the size of
your room and the wall coverings, etc. The typical example
of speaker placement and recommendations are as follows
:
Front left and right speakers and center speaker
• Place the front speakers with their front surfaces as flush
with TV or monitor screen as possible.
• Place the center speaker between the front left and right
speakers and no further from the listening position than
the front speakers.
• Place each speaker so that sound is aimed at the location
of the listener's ears when at the main listening position.
Surround left and right speakers
• Place the surround speakers approximately 60 to 90 cm (2
to 3 feet) above the ear level of a seated listener on the
direct left and right of them or slightly behind.
Surround back left and right speakers
• Place the surround back speakers at the back facing the
front at a narrower distance than front speakers.
• When using a single surround back speaker, place it at
the rear center facing the front at a slightly higher position
(0 to 20 cm ) than the surround speakers.
• We recommend installing the surround back speaker(s) at
a slightly downward facing angle. This effectively prevents
the surround back channel signals from reflecting off the
TV or screen at the front center, resulting in interference
and making the sense of movement from the front to the
back less sharp.
Subwoofer
• The subwoofer reproduces powerful deep bass sounds.
Place a subwoofer anywhere in the front as desired.
Front height left and right speakers (Recomended for
Dolby Pro Logic IIz playback)
• Place the front height speakers at least 1 meter (3.3 feet)
directly above the front speakers.
■Notes :
When using a conventional TV, to avoid interference with
the TV picture, use only magnetically shielded front
left and right and center speakers.
To obtain the best surround effects, the speakers except
the subwoofer should be full range speakers.
All manuals and user guides at all-guides.com
2. Loosen by turning the
speaker terminal counter-
clockwise.
Point slightly
downward
10
3. Insert the bare part of the
wire.
11
13
1. TV or Screen
8. Surround back left speaker
2. Front left speaker
9. Surround back right speaker
3. Subwoofer
10. Surround center speaker
4. Center speaker
11. Front height left speaker
5. Front right speaker
12. Front height right speaker
6. Surround left speaker
13. Listening position
7. Surround right speaker
• 5.1 channel speaker system :
- front(2,5), center(4), surround(6,7), subwoofer(3)
• 6.1 channel speaker system :
- 5.1 channel speaker system + surround center(10)
• 7.1 channel speaker system :
- 5.1 channel speaker system + surround back(8,9)
• 7.1 channel speaker system(for Dolby Pro Logic IIz
playback) :
- 5.1 channel speaker system + front height(11,12)
Front height speaker
At least 1 m
4. Tighten by turning it
clockwise.
12

Advertisement

Table of Contents
loading

Table of Contents