Extron electronics IP Link Pro xi IPL EXP PDU4H User Manual page 29

IPL EXP PDU4H Expansion Interface Reset Mode Summary
Use This Activation
Mode to...
Reset IP To reset all IP settings:
settings and
1. Press and hold the
port maps
LED blinks once at 3 seconds and twice at 6 seconds.
to factory
2. Release and press the
defaults
<1 second) within 1 second*. The LED blinks 3 times in quick
without
succession upon successful reset.
affecting user‑
loaded files * Nothing happens if the momentary press does not occur
within 1 second.
Start over with To reset the unit to all factory default settings:
configuration
1. Hold down the
and uploading
blinks once at 3 seconds, twice at 6 seconds, and
three times at 9 seconds.
2. Release and press the
<1 second) within 1 second*. The Reset or Power LED blinks
4 times in quick succession upon successful reset.
* Nothing happens if the momentary press does not occur
within 1 second.
NOTES:
• After performing a Reset All IP Settings or Reset to Factory Defaults reset, either set the IP address again (by
using Toolbelt) for use on your network, or turn DHCP on.
• The factory configured passwords for this device have been set to the device serial number. Passwords are
case sensitive. Performing a Reset to Factory Defaults reset sets the passwords to
Reset
button until the Reset or Power
Reset
button momentarily (for
Reset
button until the Reset or Power LED
Reset
button momentarily (for
IPL EXP PDU4H • Hardware Features and Installation
Result
Reset All IP Settings mode:
Turns DHCP off.
•
Sets the IP address back to factory default
•
( LAN port: 192.168.254.250).
Sets the subnet back to factory default
•
(255.255.255.0).
Sets the default gateway address to the
•
factory default (0.0.0.0).
Sets domain and host names to factory
•
default.
Sets port mapping back to factory default.
•
Turns events (user‑created schedules,
•
macros) off.
Stops any running program.
•
Disables 802.1X authentication.
•
Reset to Factory Defaults mode performs
a complete reset to factory defaults
(except the firmware).
Does everything Reset All IP Settings
•
mode does.
Removes (clears) all user‑loaded files
•
(except LinkLicense files) and configurations
from the control processor:
Clears driver‑port associations
•
(Ethernet) and port configurations.
Removes user‑loaded digital
•
certificates.
Removes schedules, settings, macros.
•
Clears messages in the event logs
•
table.
The unit continues to run the user‑loaded
•
firmware.
extron
.
21