Extron electronics IP Link Pro xi IPL EXP PDU4H User Manual page 27

For details of communication protocols, ports, and services used, see the
Pro Series Control Product Network Ports and Licenses Guide at www.extron.com.
LED Indication:
• Activity LED (connector and front panel) —
This yellow LED blinks to indicate network activity.
Link LED (connector and front panel) —
•
This green LED lights to indicate a good network connection.
• 100 LED (front panel) —
This green LED lights when the unit is connected to a 100 Mbps or faster network
connection.
Passwords:
IMPORTANT NOTE:
The factory configured passwords for this device have been set to the device serial
number. Passwords are case sensitive. Performing a Reset to Factory Defaults (see
Resetting the Unit
Cabling:
• For 10Base‑T (10 Mbps) networks, use a CAT 3 or better cable.
• For 100Base‑T (max. 155 Mbps) networks, use a CAT 5 or better cable.
Connect the PC that you will use for setup, the LAN port of the IPL EXP , and the control
processor and touchpanels to the same Ethernet network.
Insert
Twisted Pair Wires
Ethernet
RJ-45
Connector
Pins:
8 7 6 5 4 3 2 1
Rear Panel
IPL EXP PDU4H
MAC: 00-05-A6-XX-XX-XX
S/N: ####### E######
Activity Link
LAN
LED LED
N O C
R E L A Y R E L A Y
Figure 10.
MAC address — Each IPL EXP unit is assigned a unique
user hardware ID number (Media Access Control [MAC]
address) (for example, 00‑05‑A6‑05‑1C‑A0). You may need
this address during control processor configuration.
A label that indicates the MAC address is located on the rear of
each IPL EXP unit.
on page 20) sets the passwords to
TCP/IP
PC
Network
LAN (Ethernet)
Default protocol, public ports:
• IPL EXP IP address: 192.168.254.250
• Gateway IP address: 0.0.0.0
• Subnet mask: 255.255.255.0
• DNS address: 127.0.0.1
• DHCP client: off
• Link speed and duplex level:
autodetected
• Data rates: 10/100Base-T
LAN Connector, LEDs, and Default Protocol
IPL EXP PDU4H • Hardware Features and Installation
extron
.
Front Panel
Default login
credentials:
• Username:
admin or
user
• Password:
LINK
extron
ACT
00-05-A6-XX-XX-XX
MAC: 00-05-A6-XX-XX-XX
S/N: ####### E######
MAC: 00-05-A6-XX-XX-XX
S/N: ####### E######
100 Mbps
Connection
100
Network is
active.
IPL
Data is being
sent/received.
CONTROL SYSTEM E
MAC
Address
19