Using The Remote Control Unit - iHome iP51 Instruction Manual

OPERATING THE REMOTE CONTROL
The Remote Control controls basic functions on the iP51 and certain iPhone/iPod functions when the iPhone/iPod is docked
in the iP51. For best results, aim remote control towards the receiver.
Power On/Off/ Alarm reset
Play/Pause
Select Down/Rew
iPod navigate "menu"
Presets
Radio/Aux
EQ
Sleep
Snooze/Dimmer
Random
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory.
When the remote control stops operating or its range seems
reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2. Press to release the battery door latch.
3. Insert 1 "CR2032" 3-volt lithium battery. Make sure the
polarity (the + and – side of the battery) is correct.
4. Replace the battery door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Warning :
- Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high
temperatures & not handled appropriately.
- Do not place loose batteries in a pocket, purse, or other container containing metal objects, mix with used or other
battery types, or store with hazardous or combustible materials.
- Store in cool, dry, ventilated area.
- Follow applicable laws and regulations for transport and disposal.

Using The Remote Control Unit

10
iPod navigate "up" & "down"
Battery door
Install Remote Control Battery
Mute sound
Select Up/FF
iPod navigate "enter"
Increase volume
Decrease volume
Repeat