Using The Remote Control Unit - iHome IH24 Product Manual

Install/Replace the Remote Control Battery (for models with remote control)
To order a remote control, visit www.ihomeaudio.com
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2. Slide the battery door to release the battery door latch and remove the battery door.
3. Insert a "CR2032" 3-volt lithium battery. Make sure the polarity (the + and – side of
the battery) is correct.
4. Replace the battery compartment door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Operating the remote control
The Remote Control controls basic functions on the iH24 and certain iPod ® functions when the iPod ® is docked in the iH24.
For best results, aim remote control towards the remote sensor by the lower right corner of the display.
Move the Travel Lock Switch
Using The Optional Remote Control Unit
to Remote position to enable the remote control.
alm. reset
OFF
Turns iH24 OFF or resets alarm when alarm is sounding
Volume Buttons raise and lower volume on the unit.
Skip to previous or next track when iPod is playing, or
hold to scan current playing track.
Selects iPhone/iPod and plays track. In play mode,
press to pause
sleep
Selects Sleep Time function
Turn EXB sound enhancement ON or OFF
mute
Toggles sound ON or OFF
snooze
Snooze mode when alarm sounds, otherwise dims display
6