Using The Remote Control Unit - iHome iHL31 Quick Manual

The remote control controls basic functions on the iHL31 and certain iPod functions when the iPod is docked in the iHL31. For
best results, use the remote control within twelve feet or six meters of the unit.
Press to play or pause
your iPod.
Press to skip to the previous track
when iPod is playing; or Press and
hold to scan backwards while
listening to a song.
Lowers volume level......................
Press to turn the light
ON or OFF.
Install/Replace the Remote Control Battery
The remote control battery must be installed into the unit. When the remote control
stops operating or its range seems reduced, replace the battery with a new one.
1. The battery door is located on the bottom of the back end of the unit.
2. Grip with a fingernail or coin and pull the battery door latch.
3. Insert one "CR2032" 3-volt lithium battery (included). Make sure the polarity
(the + and the - side of the battery is facing the back of the unit).
4. Slide the battery holder back into the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY

Using the Remote Control Unit

Play/Pause
........................
Back
.......................
Vol-
.......
Light On/Off
Speaker On/Off........Press to turn the
Forward ......................
Vol+ ............................... Raises volume level.
Bass......................................Press to add bass boost.
7: remote
The remote controls all the lamp's
functions. Slide out the battery
compartment at the bottom of the
remote control and insert the 3V
lithium battery (included). You may
also use the quick-reach buttons on
the base of the lamp.
4
speaker unit ON or OFF.
Press to skip to the next
track when iPod is playing;
or Press and hold to scan
forward while listening
to a song.