Stereo alarm clock to charge your ipod or iphone (16 pages)
Summary of Contents for iHome The Portable System For Your iPhone & iPod iP27
Page 1
Model iP27 The Portable System For Your iPhone & iPod Questions? Visit www.ihomeaudio.com...
Page 2
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period. 3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($30.00 without proof of purchase).
Quick Start... 1 Controls and Indicators / iP27 Display ... 2 Using the iP27... 3-4 Replacing iP27 Backup Batteries Install/Replace Batteries for Portable Use Using The Remote Control Unit ... 6 A Consumer Guide to Product Safety... 7 Troubleshooting ... 8-9 Solucionando problemas ...
iP27 Quick start 1: AC power RESET RESET TEST T Attach AC adaptor cable to jack on back of the iP27 and plug the other end into a wall socket to play and charge iPhone/iPod Use this insert For this iPhone/iPod 4: iPhone/iPod Insert an iPhone or iPod into the dock (iPhone/IPod must not be in a “skin”...
Connect iP27 to Power Source a) For home operation and to charge your iPhone or iPod, plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120VAC wall socket. Adaptor must be plugged in to charge iPhone/iPod. b) For portable operation, install 4 “AA”...
Page 7
Using Sleep Mode • Press the Sleep Button while the iPhone/iPod is playing to enter sleep mode, and continue to press to step through the available sleep times: 90, 60, 30 or 15 minutes. The minutes set, growing gradually softer until shutting off both the unit and the iPhone/iPod at the set time. Press the Volume Up or Down controls to set your own sleep volume.
Install/Replace Backup Battery The iP27 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery Low Icon located on the left of the display is flashing, it is time to replace the backup battery. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.
Install/Replace the Remote Control Battery The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, replace the battery with a new one. 1. The battery door is located on the back end of the unit. 2.
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
Symptom Possible Problem Unit doesn’t respond AC adaptor isn’t plugged into a wall outlet (no power) or the connector is not plugged into the power supply jack on the back of the unit Wall outlet is not functioning or switched off Plug another device into the same outlet to confirm the outlet Batteries are weak or dead iPhone/iPod Using no or wrong insert...
Symptom Possible Problem iPhone/iPod didn’t Operating iP27 on batteries. The iP27 only charge charges iPhone/iPod while operating on AC power iPhone or iPod is not docked properly iPhone/iPod is locked up/ frozen iPhone/iPod battery has problem Volume level is set too high Sound is distorted Sound source is distorted Batteries are weak...
Síntoma La unidad no El adaptador de AC no está conectado al tomacorriente o el conector no está conectado funciona (no circula a la ficha en la parte posterior de la unidad corriente eléctrica) El tomacorriente no funciona Las baterías están gastadas No ha colocado el encastre del iPod, o está...
Síntoma El iPhone/iPod no El iPhone/iPod no está instalado carga correctamente El iPhone/iPod está trabado/no responde La batería del iPod podría tener algún inconveniente El sonido sale El volumen se encuentra muy alto distorsionado El sonido sale distorsionado de la unidad El control remoto no Las baterías están gastadas funciona...