Replacing Ip51 Backup Batteries; Install/Replace Backup Battery - iHome iP51 Instruction Manual

The home system for your iphone/ipod

Hide thumbs

Table Of Contents

Table of Contents

Setting the Alarms

1. Press and hold the

time (hold for a few seconds to advance or reverse rapidly). Remember to set the correct AM or PM wake time.

2. Press the

Button again. The currently selected alarm frequency will flash. Press the

the alarm for 7 days (everyday), 5 days (week days) or 2 days (weekends). Make sure the calendar is properly set for accurate

wake frequency.

3. Press the

Button again. The current wake source display will flash. Press the

Playlist, Radio or Buzzer to wake to.

4. Press the

Button again or wait for 10 seconds. The alarm is now armed, indicated by the numbered alarm clock icon.

NOTE: To wake to playlist mode, first create a playlist named 'ihome' on your iPhone/iPod.

Arming and Disarming Alarms (Turn Alarm Function On and Off)

1. Alarms are automatically armed when set, indicated by the alarm icon. Press the

Resetting the Alarm to Come on the Next Day

1. When the alarm is sounding, press the

at the same time.

Snooze

1. Press and hold Snooze Button to adjust snooze timer from 1 to 30 minutes.

2. Press the Snooze Button after the alarm sounds. The alarm will be silenced and come on again 9 minutes later.

Snooze can be pressed several times during the 1 hour alarm cycle.

Sure Alarm

The iP51 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will sound in the event of a power failure.

If your iPhone/iPod has no sound for 20 seconds or is not present, the iP51 will switch to buzzer alarm automatically.

Install/Replace Backup Battery

The iP51 uses a backup battery system to provide continuous clock settings in the event of a power failure.

If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup batteries.

Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.

• Open the battery compartment cover located on the bottom of the main receiver unit. Insert 2

"AA" batteries as indicated. We recommend the use of alkaline batteries for longer life.

• Please make sure the AC cord is connected; otherwise all settings may be lost during

battery replacement.

Batteries information:

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.

Using the Alarms

Button until the alarm time display flashes. Press the

Button to stop the alarm and reset it to come on the following day