Related Manuals for iHome iP51
Summary of Contents for iHome iP51
- Page 1 Model iP51 The Home System ® For Your iPhone/iPod Questions? Visit www.ihomeaudio.com...
-
Page 2: Table Of Contents
Safety Instructions FCC Information Batteries information Quick Start ... 4-5 Controls and Indicators ... 6 Using the iP51 ... 7-9 Replacing iP51 Backup Batteries Install/Replace Backup Battery Using The Remote Control Unit ... 10 Troubleshooting ... 11-12 Warranty Information ... 13 •... -
Page 3: Caution Information
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user of the presence of uninsulated “dangerous voltage”... -
Page 4: A Consumer Guide To Product Safety
A Consumer Guide to Product Safety 1. Read these Instructions. 2. Keep these Instructions. 3. Heed all Warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. -
Page 5: Fcc Information
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area. -
Page 6: Quick Start
R speaker composite L speaker Snap the AM antenna into the provided stand, then plug the antenna cable into the socket on the back of the iP51. Move the antenna 12” away. 2: speakers speaker r R speaker composite Attach a speaker cable from the right speaker (R speaker) and left speaker (L speaker) jacks on the back of the receiver to the jack on the back of each matching speaker. - Page 7 Insert 15 For this iPhone/iPod iPhone 3G NOTE: If you do not have an insert for your iPhone/iPod, please visit www.ihomeaudio.com or call iHome toll free at 877-446-6301 to purchase one. 8:radio Press the Radio/Aux button as needed to select AM/FM band.
-
Page 8: Controls And Indicators
RECEIVER (top panel) Universal dock Preset Buttons Alarm 1 Button Select Down/ REW Button Alarm Reset/ Power Button Play/Pause Button RECEIVER (rear panel) Right Speaker Jack Composite Jack R speaker Controls and Indicators Snooze/Dimmer Select Up/ Button FF Button Clock Adjust Button Line in Jack composite Time Zone Button... -
Page 9: Using The Ip51
3. Attach the other end of the cable to the Receiver and tighten screws until firmly attached. Connecting the Stereo Speakers to the Receiver 1. The iP51 comes with two sets of audio cables (short and long) so you can set up the speakers to match your setting and preferences. - Page 10 Use an audio patch cord (available at www.ihomeaudio.com) to play nondocking iPhone/iPod models or other audio devices through the iP51 Line-in Jack (one end in the device’s line out or headphones jack, the other in the iP51 line in jack). Press the Radio/Aux Button until LINE IN appears in the display.
-
Page 11: Replacing Ip51 Backup Batteries
Sure Alarm The iP51 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will sound in the event of a power failure. If your iPhone/iPod has no sound for 20 seconds or is not present, the iP51 will switch to buzzer alarm automatically. -
Page 12: Using The Remote Control Unit
OPERATING THE REMOTE CONTROL The Remote Control controls basic functions on the iP51 and certain iPhone/iPod functions when the iPhone/iPod is docked in the iP51. For best results, aim remote control towards the receiver. Power On/Off/ Alarm reset Play/Pause Select Down/Rew iPod navigate “menu”... -
Page 13: Troubleshooting
Please make sure your iPhone/iPod is working properly before docking into the unit. Please refer to your iPhone/iPod manual for details. generation iPhone/iPod iP51 cannot control those iPhone/iPod or other devices. Wake up iPhone/iPod (see your iPhone/iPod manual for details) Solution... - Page 14 If you are using an external sound source like older generation of iPhone/iPod or other audio device, try reducing the output volume on the device itself. Try adjusting EQ settings on your iPhone/iPod/iP51/sound source. Move closer to unit Replace current battery with new battery...
-
Page 15: Warranty Information
Limited 1 Year Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one year from the date of original purchase.