Steps
1. Align the notch on the 2280 solid-state drive with the tab on the SSD slot two on the system board.
2. Insert the 2280 solid-state drive at a 45-degree angle into the system board.
3. Press the other end of the 2280 solid-state drive down and replace the screw (M2x3) that secures the 2280 solid-state drive to
the system board.
Next steps
1. Install the
left-side
cover.
2. Follow the procedure in
3. Verify if the storage device is installed correctly (optional):
a. If you are replacing a storage device which does not have the operating system installed, follow the steps in
storage device in device
b. If you are replacing a storage device which does not have the operating system installed, follow the steps in
storage device in system setup
Top bezel
Removing the top bezel
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
cover.
3. Remove the
top
cover.
4. Remove the
right-side
About this task
The following images indicate the location of the top bezel and provide a visual representation of the removal procedure.
After working inside your
manager.
(BIOS).
Before working inside your
cover.
computer.
computer.
Identifying
Identifying your
51